Intuitive design
It’s a very simple concept that works better than it seems like it should. Mag retention is strong, and indexing mags into the inserts is surprisingly easy.
It’s a very simple concept that works better than it seems like it should. Mag retention is strong, and indexing mags into the inserts is surprisingly easy.
Works as intended with the chest rig, holds my mags. GEN 3 PMAGs are a tight fit though just due to the design (A little tip to install these is cut out two pieces of cardboard to cover the Velcro as you slide the inset in)
It’s a very simple concept that works better than it seems like it should. Mag retention is strong, and indexing mags into the inserts is surprisingly easy.
Works as intended with the chest rig, holds my mags. GEN 3 PMAGs are a tight fit though just due to the design (A little tip to install these is cut out two pieces of cardboard to cover the Velcro as you slide the inset in)
I run an Ak and the mags still fit pretty good facing up. Good retention. Would recommend
Great product excellent retention. Works with other brands plate carriers also.
Installation was easy, holds my mags perfectly In place. Even while running and jumping my mags stay right where I need them until I need them.
Fits in a Micro - better than the kydex inserts from HS in my opinion- better retention on STANAG mags than theirs.
While it specifies that the 7.62 inserts are for NATO mags, your banana bois from the Motherland will fit, too
This product is great. Note that it has hook on both sides. (hook and loop)
Does exactly what its supposed to!
quality is Really good the mags are held really tight which in some cases is good but if you want a looser fit leave the mags in over night to stretch it out and both sides have hook Velcro just if anyone is wondering
WARNING: This insert is ONLY compatible with the Micro Fight MK5 MK4 and MK3 Chassis. It is not compatible with the MK2 or MK1 Chassis, nor plate carrier kangaroo pouches.
WARNING: The MRAD Multi-Cal Insert is only compatible with the MK5 Chassis.
The Micro Fight Magazine Insert is a custom solution to a common problem. Instead of using pull tabs, hook & loop, snap flaps. or a hard kydex insert; we have chosen to use something a little more versatile.
Using elastic is very quiet when removing or adding magazines, giving you quick and easy access to your magazines while providing excellent retention. Elastic will not deform due to heat over time and although it will loosen some with use, it will still provide excellent retention of your magazines. The magazine insert is retained by hard loop field sewn to both sides. This allows for the insert to fit in the front and rear pockets of the Micro Fight Chassis (MK3 and Mk4). The Micro Fight Rifle Magazine Insert will accept both PMAGS and USGI magazines.
This is a critical component of the Micro Fight Chest Rig System. You can place an insert in both the front and rear pocket of your Micro Fight Chest Rig. This will enable you to hold a total of 6 x 5.56 Magazines or 4 x 7.62 Magazines.
Available in Jet Black Only
The Micro Fight Rifle Inserts are currently available in the following configurations:
5.56 x .45 - 3 magazines, single stack. Dimensions 9" x 4"
7.62 x .51 - 2 magazines, single stack. Dimension 7.75" x 4"
7.62 x .51 (HK) 2 magazines, single stack. Dimensions 9" x 4"
NOTE: The MAGAZINE INSERT is a required product for the Micro Fight Chest Rig System.
Some images shown with optional accessories, sold separately.
If you are ordering for a MIL/LEO unit, please contact sales@spiritussystems.com
